Table of Contents
Advertisement
Assigning surface-mounted home station video via floor-call button
42
If you cannot access the flat during start-up, you
can also assign the surface-mounted home station
video via a connected floor-call button:
1. Control device: press the "Systemprogr." but-
ton for 3 s to start the programming mode.
2. Press the call button on the door station for
3 s. Release the call button following the brief
acknowledgement tone sounds.
The door station outputs a long acknowledge-
ment tone.
3. Press the floor-call button of the home
station to be asseigned for 3 s. Release the
floor-call button after the brief acknowledge-
ment tone sounds.
A long acknowledgement tone indicates
successful assignment.
Only possible with home
i
station connected directly
With several parallel home stations, only the
home station connected directly to the floor-call
button can be taught in via the floor call button.
4. Briefly press the "Systemprogr." button on
the control device to exit the programming
mode.
Advertisement
Table of Contents
