Table of Contents
Advertisement
Assigning a flush-mounted home station to surface-mounted home
station video
40
A voice connection between two home stations
can be established via the internal call.
To assign a flush-mounted home station call but-
ton to the surface-mounted home station video,
please proceed as follows:
1. Control device: press the "Systemprogr." but-
ton for 3 s to start the programming mode.
2. Press the call button on the flush-mounted
home station for 3 s. Release the call button
following the brief acknowledgement tone
sounds.
The home station outputs a long acknowl-
edgement tone.
i
Releasing the button after 3 s
If the button is not released after the first
acknowledgement tone, all call buttons of the
home station will be deleted after an additional
3 s.
3. Press the button
home station video for 3 s until a brief
acknowledgement tone is heard.
A long acknowledgement tone indicates
successful assignment.
Three short acknowledgement tones indicate
faulty assignment. The memory of the
surface-mounted home station video may
already be occupied. A maximum of 24 call
buttons can be assigned.
4. Briefly press the "Systemprogr." button on
the control device to exit the programming
mode.
on the surface-mounted
Advertisement
Table of Contents
