Table of Contents
Advertisement
PROGRAMMING STEPS
Step 7 - Repeat steps 2 through 6 to continue identifying the Master Key Pages where the IR commands are stored for
all the steps in the Master Key Sequence you are programming.
Step 8 - Press the PROGRAM key to program the Master Key Sequence for a different Master Key.
The TRIGGER LED turns on RED, and the PAGE LED continues to blink RED.
Step 9 - Repeat steps 1 through 8 until all Master Key Sequences have been programmed.
Note: If you missed IR commands in a sequence, re-do the programming for the whole sequence. When you reach step
3 and press the actual Function Key that triggers the sequence, whatever was previously programmed for that key is auto-
matically erased. To erase programming after it has been saved, see Erasing Programming.
Step 10 - Press NEXT to continue programming.
The INPUT ASSIGN/ZONE-SYS. SEQ.
The TRIGGER LED is on RED.
LED turns on GREEN,
The LED for Zone 1 blinks GREEN, to indicate that Zone 1 is selected by default.
78
Advertisement
Table of Contents
