PROGRAM-EDITING STEPS
EDIT SOURCE-COMPONENT POWER
Steps to edit the IR commands to power IR activated source components.
Step 1
Press and hold the PROGRAM button.
-
The POWER/(MASTER KEY SEQ) LED turns on RED, and the PAGE LED blinks, RED.
Step 2
Press a Master Key where you will edit source component power IR commands.
-
Important Note: Every Master Key that activates a source component with IR must be programmed individually.
The PAGE LED turns off, and the ENTER IR LED turns on GREEN.
Step 3
Press the appropriate Power or ON button on the original factory remote.
-
The ENTER IR LED turns on RED to indicate it is ready to receive the OFF command.
Step 4
Press the OFF button on the original factory remote if the component has discrete ON and OFF commands.
-
The ENTER IR LED turns off, and the PAGE LED blinks RED.
or
Press the PROGRAM button if the component has a single power command for ON and OFF.
The ENTER IR LED turns off, and the PAGE LED blinks RED.
Step 5
To test the command(s), press the TEST button. If it does not operate the component as expected,
-
teach and test the command again until it does.
Note: Repositioning the remote control when teaching the command can assist in capturing commands accu-
rately.
Step 6
If there are other Master Keys to edit, press the appropriate Master Key and then repeat steps 3
-
through 5 until you have edited all the power commands.
Step 7
Press Next to edit Input Selection. The INPUT ASSIGN /(ZONE-SYS. SEQ.) LED turns on RED, and
-
the PAGE LED blinks RED.
or
Step 8
Press PROGRAM to save and exit programming.
-
EDIT INPUT SELECTION
Steps to edit the assigned audio input for the Master Keys.
Step 1
Press and hold the PROGRAM button.
-
Step 2
Tap the NEXT button once.
-
The INPUT ASSIGN /(ZONE-SYS. SEQ.) LED turns on RED, and the PAGE LED blinks RED.
Step 3
Press the Master Key to edit.
-
The PAGE LED turns off. Either the number 1 INPUT LED turns on RED (by default) or the previously pro-
grammed INPUT LED turns on RED.
Step 4
Press the INPUT SELECT button on the front panel to choose the input for that Master Key. When
-
the desired INPUT LED is turned on, press PROGRAM to assign it.
The INPUT LED turns off and the PAGE LED blinks RED.
88