Fujitsu WGYA050DG6 Design & Technical Manual page 146

Floor curing function
•
Off
The function is deactivated.
•
Heating operational (Fh)
The first part of the temperature profile is
automatically completed.
•
Heating "ready for occupancy" (Bh)
The second part of the temperature profile is
handled automatically.
•
Heating "ready for occupancy" /
Heating operational
The full temperature profile (1st and 2nd part) is
performed automatically.
Heat pump
flow temp
X : Starting day
Floor curing setpoint manually
The flow temperature setpoint for the "Manually"
controlled floor drying function can be adjusted
respectively for each heating circuit.
Floor curing day current
Displays the current flow temperature setpoint for
the controlled floor drying function.
Operating Mode Changeover
LINE
HC1 HC2
900 1200
In case of an external changeover via input H2 (on
the extension module only) the operating mode to
which the changeover will be performed must be
previously defined.
•
Manual
No temperature profile is performed, but the control
is performed according to the "manual controlled
drying setpoint". The function is automatically
terminated after 25 days
Important:
- The standards and directions of the building
contractor must be followed!
- This function will not work properly unless
the installation has been adequately made
(hydraulics, electricity, settings). Otherwise, the
floors to be dried may be damaged!
- The function may be prematurely interrupted by
setting it to Off.
The maximum flow temperature limitation
-
remains active.
Fh
Bh
Fh + Bh
Floor curing day completed
Displays the current day of the controlled floor
drying function.
Important:
After a power outage, the installation resumes the
controlled drying function as it was when the
outage occurred.
FUNCTION
Operating mode changeover
(None / Frost protection mode / Reduced / Comfort / Automatic)
- (CS01 - 30) - - (CS01 - 30) -
Days
Control system