Fujitsu WGYA050DG6 Design & Technical Manual page 138

z „
Operator section functions
LINE FUNCTION
20 Language
22 Info
Operation lock
26
27 Programming lock
28 Direct adjustment
29 Temperature unit
Pressure unit
Info
•
Temporary
After pressing the Info key, the information display
returns "predefined" basic display after 8
minutes or when pressing the operating mode key.
•
Permanently
After pressing the Info key, the information display
returns to "new" basic display after a maximum of
8 minutes. The last selected information value is
shown in the new basic display.
Operation lock
If the operating lock is activated, the following
control elements can no longer be adjusted:
Heating circuit mode, DHW mode, room temp
comfort setpoint (knob), occupancy key.
Heating Circuit Assignment
LINE FUNCTION
70 Software version (user interface)
„
applies only to Remote control C75
*
Software version (user interface)
The display shows the current version of the user
interface.
Programming lock
If the programming lock is activated, the setting
values are displayed but may no longer be
changed.
Temporary suspension of programming:
The programming lock can be temporarily
deactivated at programming level. To do this,
simultaneously press OK and ESC keys for at
least 3 seconds. The temporary suspension of the
programming lock remains in effect until you exit
the programming.
Permanent suspension of programming:
First perform a temporary suspension, then cancel
"Programming lock" on line 27.
Direct adjustment
• Storage with confirmation
Correction of the setpoint with the knob will be
adopted only after pressing OK key.
•
Automatic storage
Correction of the setpoint with the knob is adopted
without a particular confirmation (timeout) or by
pressing OK key.
- (CS01 - 22) - - (CS01 - 22) -
Control system