Specifications; Electrical Safety; General Power Tool Safety Warnings - Maktec MT810 Instruction Manual

ENGLISH
1. Grip base
2. Side grip (auxiliary handle)
3. Teeth
4. Protrusion
5. Loosen
6. Tighten
7. Drill chuck

SPECIFICATIONS

Model
Concrete
Capacities Wood
Steel
No load speed (min
Blows per minute
Overall length
Net weight
Safety class
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
..... Read instruction manual.
.............. DOUBLE INSULATION
Intended use
The tool is intended for impact drilling in brick, concrete
and stone as well as for drilling without impact in wood,
metal, ceramic and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.

General Power Tool Safety Warnings

WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Explanation of general view
8. Chuck key
9. Sleeve
10. Ring
11. Side grip
12. Depth gauge
13. Hex washer
14. Hex bolt
MT810
10 mm
18 mm
10 mm
-1
) 0 - 2,800
0 - 30,800
258 mm
1.6 kg
MT811/MT812
13 mm
18 mm
13 mm
0 - 2,800
0 - 30,800
272 mm
Save all warnings and instructions for future
END201-5
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool.
Work area safety
1. Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
2. Do not operate power tools in explosive atmospheres,
such as in the presence of flammable liquids, gases or
ENE039-1
dust. Power tools create sparks which may ignite the
dust or fumes.
3. Keep children and bystanders away while operating a
power tool. Distractions can cause you to lose control.

Electrical safety

ENF002-1
4. Power tool plugs must match the outlet. Never modify
the plug in any way. Do not use any adapter plugs with
earthed (grounded) power tools. Unmodified plugs
and matching outlets will reduce risk of electric shock.
5. Avoid body contact with earthed or grounded surfaces
such as pipes, radiators, ranges and refrigerators.
There is an increased risk of electric shock if your
body is earthed or grounded.
GEA005-3
6. Do not expose power tools to rain or wet conditions.
Water entering a power tool will increase the risk of
electric shock.
7. Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool. Keep
cord away from heat, oil, sharp edges or moving parts.
Damaged or entangled cords increase the risk of
electric shock.
15. Dot
16. Switch trigger
17. Lock button
18. Reversing switch lever
19. Action mode changing lever
1.9 kg
/II
MT813
16 mm
30 mm
13 mm
0 - 3,000
0 - 45,000
297 mm
2.2 kg
3