Regency L390PB Owners & Installation Manual page 32

INSTALLATION
5) Position Log 3 in front and to the right of Log 1. Log 3 fi ts in a recess in
the burner tray. Pull log forward on the burner tray until it rests against
the ridge in the burner tray shown below.
1
Ridge in burner tray (highlighted)
6) Position Log 4 in front and to the right of Log 3. Log 4 fi ts in a recess in
the burner tray. Pull log forward on the burner tray until it rests against
the ridge in the burner tray shown below.
Ridge in burner tray (highlighted)
7) When installed - ensure the air gap at the rear of the log is maintained -
as indicated by arrow below.
919-238
32
3
4
8) Identify the locators for Log 5 - a pin on Log 1 and a cavity in the front
right corner on the burner tray as shown below.
Pin on Log 1 (highlighted)
9) Orient Log 5 as shown below - then match up locators on log with those
in the fi rebox (indicated above).
10) Correct positioning of Log 5 is shown below.
Log 5 - correct position L
Log 5 - correct position installed
2
Cavity in burner tray (highlighted)
Log 5 - correct position R
02/15/13
390 390
L PB-2 / HZI PB-2 Direct Vent Gas Insert