Regency L390PB Owners & Installation Manual page 23

9. Bundle excess wires and power cord - with the exception of the wire
marked receiver.
Receiver wire requires enough slack to reach the front left of the unit
to be connected to the receiver.
Secure wires with cable ties installed in previous step.
Additionally secure wires with a wire clip to be installed in location
shown below.
Right
Wire Clip
Cable Tie
Cable Tie
Receiver Wire
10. Install receiver onto backing plate with 2 screws and plug in
receiver cord shown in Step 9.
11. Connect receiver wire from the wiring harness to the back side of
the remote receiver as shown below
390 390
L PB-2 / HZI PB-2 Direct Vent Gas Insert
12. Bundle excess receiver wire using the 4th cable tie and secure to
the front left of the fi rebox as shown below.
Left
Cable Tie
13. Plug the 10 foot extension cord into the FCM extension cord as
shown below.
14. Install a grommet on power cord near the three prong plug
connection made in previous step and secure to the faceplate as
shown below.
Note: 3 prong plugs should be left behind the faceplate after
installation is completed.
INSTALLATION
Grommet
23