Yealink SIP-T21 E2 User Manual page 88

User Guide for the SIP-T21(P) E2 IP Phone
Using the headset

You can also dial the number first, and then choose the way you want to speak to the
other party.
You can also search and dial a contact from call history, local directory or remote phone
book. For more information, refer to
Management
During a call, you can alternate between Speakerphone, Headset and Handset modes
by pressing the Speakerphone key, the HEADSET key, or by picking up the handset.
The call duration of the active call and far-site's information (name or phone number)
are visible on the LCD screen. In the figure below, the call to "Tom" (the phone number:
1058) has lasted 8 seconds.
To place a call using the handset:
1. Pick up the handset.
2. Enter the desired number using the keypad.
3. Press
The # key is configured as a send key by default. You can also set the * key as the send
key, or set neither. For more information, refer to
You can also dial using the SIP URI or IP address. To obtain the IP address of a phone,
Note
press the OK key when the phone is idle. The maximum SIP URI or IP address length is 32
characters. For example, SIP URI: 2210@sip.com, IP: 192.168.1.15.
Your phone may not support direct IP dialing. Contact your system administrator for more
information.
To place a call using the hands-free speakerphone mode:
Do one of the following:
With the handset on-hook, press
-
Enter the desired number using the keypad.
Press
- With the handset on-hook, enter the desired number using the keypad.
Press
78
Contact Management
on page 51.
, , or the Send soft key.
, , or the Send soft key.
, , , or the Send soft key.
on page
Key as Send on page 30.
or the line key to obtain a dial tone.
35 and Call History