Using The Machine; Filling The Water Tank; Switching On The Machine; Display Language Selection - LAVAZZA LB2300 SINGLE CUP Operating Instructions Manual

4

USING THE MACHINE

4.1

Filling the water tank

Note: this operation only needs to be car-
ries out for machines NOT connected to the
water network.
Before switching on the machine, the water tank should
be fi lled with fresh drinking water.
Warning! Before using the machine for the
fi rst time, wash the water tank carefully.
The tank should be fi lled only with fresh drinking
water, as hot water, carbonated water or other liq-
uids will damage the machine.
Using the key supplied with the machine, open the tank
cover and lift to remove it.
Remove the water tank from its seat using the appropri-
ate handle.
Fill the water tank with fresh drinking water.
When fi lling the tank, never exceed the limit
indicated with an arrow.
After fi lling the water tank, replace it in its seat taking
care to insert it correctly, so that the valve located at
the base of the tank is open, allowing the machine to
operate properly.
Replace the water tank cover. Close the cover using
the key supplied with the machine.
The machine is now ready to be switched on and
used to dispense the desired products.
4.2

Switching on the machine

Warning! Connection to the power supply
should be carried out exclusively by the
service provider!
Before switching on the machine, ensure that the plug
is correctly inserted in the power socket.
Use of the machine - User Manual
To switch on the machine, move the power button on
the back of the machine to "I" (Fig.03, page 3).
The display shows:
At this point the machine is warming up.
When the machine reaches the right temperature for
brewing the beverage, the display shows:
Lavazza
Ready
Insert capsule
The machine is now ready to dispense coffee, hot
water and/or steam.
4.3

Display language selection

The machine is designed to display messages in a
number of languages.
According to your type of machine, follow these instruc-
tions to change the language:
For machines WITHOUT the (24) button:
please read section 7.1., which describes the
procedure to change the language.
For machines with the (24) button:
press button (24), for 1 second, to scroll through
the languages supported by the appliance; release
it when the desired language is shown.
For example:
English
At this point the display shows messages in the se-
lected language.
Note: the language can be selected at any
time while the machine is in operation, ex-
cept when hot water or steam is being dispensed.
4.4

Using cups, mugs and glasses

Warning! Containers which protrude from
the support grills may not be used.
The machine is designed to correctly dispense bever-
ages into small cups and/or larger containers.
Cups and/or mugs should be correctly positioned under
the dispensing spout.
Note: if cups and/or mugs are not correctly
positioned under the dispensing spout, the
beverage may spill out of the container.
To use small cups, lower the upper cup rest (Fig.04,
page 3).
To use large mugs and/or glasses, use the lower grill;
gently lift the upper cup rest (Fig.05, page 3).
4.5

Rinsing of the internal circuits

The purpose of this function is to rinse the machine's
internal circuits.
This process dispenses hot water via the dispensing
spout (4), cleaning all components involved in dispens-
ing in order to prepare the next beverage or coffee with-
out the taste of whatever was dispensed previously.
Please read section 7.4., which describes
the procedure to set the rinse cycle.
To perform the rinse cycle, press button (14) for 1 sec-
ond. The display shows:
Lavazza
Rinsing
C to terminate
Enter to confirm
To NOT perform the rinse cycle, press (21).
To perform the rinse cycle, press (15). The display
shows:
Lavazza
Rinsing
in progress
Wait please...
The machine automatically controls the amount of hot
water dispensed via the dispensing spout.
Wait for the rinse cycle to end.
Lavazza
The display shows:
Ready
Insert capsule
The machine is now ready for use, and the circuit has
been rinsed.
4.6

Loading capsules

Warning! The desired products should be
prepared exclusively using capsules sup-
plied directly by the service provider.
Capsules other than those supplied by the
service provider, coffee beans, ground and/
or freeze-dried coffee should not be used.
Capsules should not be reused to prepare
two or more products.
To insert the capsule, the loading tray must be opened
by pulling it outwards as far as it will go (Fig.06, page
3). The display shows:
Lavazza
Insert capsule
Close drawer
Warning! Do not force the tray beyond its
normal range of movement.
Pick up a single capsule and rest it in the seat in the
tray (Fig.07, page 3).
.
• 7 •