Advertisement
FUNCTION CHECK
Operating Conditions
• The hood is closed.
• The shift lever is in park.
• The key is not in the ignition switch.
• All doors and tailgate are closed and locked.
Inspection
1.
Within 1 second, press the command button and then the start button on the transmitter.
The engine should start if all operating conditions are met.
Does the engine start?
Yes - Operation is normal.
No:
• Make sure all operating conditions are met.
• Check the engine starter harness connections.
• Connect the HDS and check for an indicated failure.
(Refer to the appropriate service manual for details.)
2.
Press the command button on the transmitter, and within 1 second,
press the stop button. The engine should stop.
Does the engine stop?
Yes - Operation is normal.
No - Check the engine starter harness connections.
3.
After the engine has stopped, start the engine again, and check that
the engine stops after each of the following conditions:
NOTE:
• Each test must be completed within 30 seconds after engine starts.
• After each test the ignition switch must be cycled, or the driver's
door must be opened and closed.
-
Move the shift lever out of the P position.
-
Unlock or open the doors or the trunk lid.
-
Open the hood.
-
Insert the key in the ignition switch.
-
Press the brake pedal.
Does the engine stop after each of these tests?
Yes - Operation is normal.
No - Check the engine starter harness connections.
4.
Check that the power windows or the moonroof does not function when the engine is started with the transmitter.
5.
Press the command button on the transmitter twice and check the vehicle condition on the display.
6.
Check the operation of the transmitter when the vehicle is 100 m to 150 m (325 ft. to 490 ft.) away and when the
vehicle is in direct sight.
24 of 24
AII 35365 (0708)
DISPLAY
STOP
BUTTON
START
BUTTON
TRANSMITTER
© 2007 American Honda Motor Co., Inc. – All Rights Reserved.
COMMAND
BUTTON
732904AY
Advertisement
