Function Check - Honda 08E91-E22-101A Installation Instructions Manual

FUNCTION CHECK

Operating Conditions
• The hood is closed
• The shift lever is in park
• The key is out of the ignition and the key is outside the vehicle
• All doors and tailgate closed and locked
Inspection
1. Within 1 second, press the command button, and then the start button on the transmitter.
The engine should start if all operating conditions are met.
Does the engine start?
Yes - Operation is normal.
No:
• Make sure all "Operating Conditions" are met.
• Check the engine starter harness connections.
• Connect the HDS and check for an indicated failure.
(Refer to the appropriate service manual for details.)
2. Press the command button on the transmitter, and within 1
second, press the stop button. The engine should stop.
Does the engine stop?
Yes - Operation is normal.
No - Check the engine starter harness connections.
3. After the engine has stopped, start the engine again, and
check that the engine stops after each of the following
conditions:
NOTE:
• After each test the ignition key must be cycled, or the driver's
door must be opened and closed.
• Move the shift lever out of the P position.
• Unlock or open the doors or the tailgate.
• Open the hood.
• Insert the key in the ignition.
• Press on the brake pedal.
Does the engine stop after each of these tests?
Yes - Operation is normal.
No - Check the engine starter harness connections.
4. Check that the power window or the moonroof does not function and the shift lever does not move to any position
when the engine is started with the transmitter.
5. Start the engine again, press the command button on the transmitter two times and check the vehicle condition on
the display.
6. Check the operation of the transmitter when the vehicle is 100 m to 150 m (325 to 490 ft.) away and in direct sight.
© 2010 American Honda Motor Co., Inc. – All Rights Reserved.
STOP
BUTTON
TRANSMITTER
AII 43923 (1009)
DISPLAY
COMMAND
BUTTON
START
BUTTON
732904AY
22 of 22