Advertisement
24. Remove the vehicle bolt and remove the TPMS
control unit from the vehicle bracket.
TPMS CONTROL UNIT
STEERING
SHAFT
25. Route the 12-pin/8-pin/5-pin connector end of the
engine starter harness over the brake pedal bracket
towards the center of the vehicle.
ENGINE STARTER
HARNESS
BRAKE PEDAL
BRACKET
12-PIN/8-PIN/5-PIN CONNECTOR
8 of 24
VEHICLE
BRACKET
VEHICLE
BOLT
6D18091Y
STEERING
SHAFT
VEHICLE
BRACKET
6D1810AY
26. Route the 12-pin, 8-pin, and 5-pin connector end of
the engine starter harness to the ignition switch.
5-PIN
CONNECTOR
2
Pull.
Push.
Unlock connector
27. Disconnect the vehicle 5-pin connector from the
ignition switch, and plug the engine starter harness
5-pin connector into the ignition switch.
NOTE: Check that the engine starter harness 5-pin
connector is connected to the vehicle connector and
locked securely. A loose connector can cause
engine to stall.
AII 35365 (0708)
VEHICLE 5-PIN
CONNECTOR
IGNITION
SWITCH
ENGINE STARTER
HARNESS
2
1
Push.
3
Lock connector
© 2007 American Honda Motor Co., Inc. – All Rights Reserved.
12-PIN/8-PIN/5-PIN
CONNECTOR
1
6D1812DY
Advertisement
