Honda 08E91-E22-100A Installation Instructions Manual page 7

Setting the Control Unit
20. Using a small flat-tip screwdriver, adjust the switches
on the (accessory) control unit to the locations
shown. Using isopropyl alcohol on a shop towel,
clean the area where the protective tape will attach.
Remove the adhesive backing, and attach the
protective tape to the control unit.
NOTE:
• If the switch setting is not correct the remote
engine starter will not operate correctly.
• If adjusting the switches with the control unit
installed in the vehicle, touch the metal part of
the screwdriver to any metal part of the vehicle
to discharge any static electricity.
CONTROL
UNIT
PROTECTIVE
TAPE
ADHESIVE
BACKING
SW:1 RR Junction unit
SW:2 Trunk or Tailgate
SW:3 Smart Entry
SW:4 Horn or Buzzer Answerback
SW:5 Trunk Main SW
SW:6 Reserve
© 2007 American Honda Motor Co., Inc. – All Rights Reserved.
SWITCH
Clean with
isopropyl alcohol.
7111031Y
Routing the Engine Starter Harness
21. Attach the two 40A fuse labels to the engine starter
fuse block.
FUSE BLOCK
22. Attach the 3A fuse label to the engine starter relay
block.
23. Install the three relays to the engine starter relay
blocks.
ENGINE
STARTER
HARNESS
AII 35365 (0708)
40A FUSE LABELS
3A FUSE LABEL
ENGINE
STARTER
HARNESS
3 4-PIN
RELAYS
RELAY
BLOCK
732821BY
6D1802BY
7 of 24