Honda 08E91-E22-100A Installation Instructions Manual page 10

32. Secure the engine starter harness to the vehicle
harness with two wire ties in the areas shown.
VEHICLE
HARNESS
2 VEHICLE
CLIPS
33. Disconnect the vehicle 20-pin connector from the
TPMS control unit (removed in step 24), and plug it
into the engine starter harness 20-pin connector.
Plug the remaining engine starter harness 20-pin
connector into the TPMS control unit.
VEHICLE 20-PIN
CONNECTOR
20-PIN
CONNECTOR
10 of 24
VEHICLE
WIRE TIE
HARNESS ENGINE
STARTER
2 WIRE
HARNESS
TIES
Inside.
ENGINE
STARTER
HARNESS
TPMS CONTROL
UNIT
ENGINE STARTER
HARNESS
20-PIN
CONNECTOR
VEHICLE 20-PIN
CONNECTOR
34. Align the green tape on the engine starter harness
with the clip on the vehicle harness, and secure the
engine starter harness to the vehicle harness with
one wire tie.
6D1817BY
35. Near the connector, secure the engine starter
harness to the vehicle harness with one wire tie.
36. Secure the engine starter harness to the vehicle
6D1818AY
harness with two long wire ties at the locations
shown.
AII 35365 (0708)
VEHICLE
HARNESS
ENGINE
STARTER
HARNESS
WIRE TIE
ENGINE STARTER
HARNESS
© 2007 American Honda Motor Co., Inc. – All Rights Reserved.
VEHICLE
CLIP
GREEN
TAPE
WIRE TIE
6D1811AY
LONG WIRE
TIES
VEHICLE
HARNESS
CONNECTOR
VEHICLE
HARNESS
6D1819EY