Baumatic BWMI1216 Instruction Manual page 24

Err4
o Heater error (appears at the end of a cycle).
 Contact the Customer Care Department.
Err5
o Machine does not fill to the specified level within 8 minutes.
 Check that the inlet hose is not kinked or blocked and that the
water tap is connected the machine and is fully open.
 Check that the drainage hose is not below 80cm.
Err7
o Motor error
 Contact the Customer Care Department.
Err8
o Machine has filled to an abnormal level.
 Contact the Customer Care Department.
Er10
o Faulty water level sensor.
 Contact the Customer Care Department.
EuAr
o Electrical fault – the PCB is not communicating with the motor.
 Turn off the power and restart the machine in the first instance
which may clear the fault.
 If this does not clear the fault then contact the Customer Care
Department.
End
o No Fault – Indicates the end of a wash cycle.
UNb
o After the last rinsing cycle has finished, the spinning cycle has failed
due to unbalance of the laundry
 After a few minutes the door will become unlocked and you can
remove your clothes.
 If you desire to spin dry your laundry then turn the wash
programme selection knob to the "off" position, turn the wash
programme selection knob to the spin programme then press the
Start/pause button.
 Contact the Customer Care Department.
24