Motorola AP-6511 Installation Manual page 16

16
9. Snap the AP-6511 on to the mounted wall plate and secure the AP-6511 using the mounting plate lock
screw. This connection does not require the use of tools or fastening hardware.
10. Cable the Access Point using a Power Injector solution (AP-PSBIAS-2P2-AFR) as described in the
following:
e. Connect an RJ-45 CAT5 Ethernet cable between the network data supply (host) and the Power
Injector's Data In connector.
f. Connect an RJ-45 CAT5 Ethernet cable between the Power Injector's Data & Power Out connector
and the AP-6511 Access Point.
g. Ensure the cable length from the Ethernet source (host) to the Power Injector and Access Point does
not exceed 100 meters (333 ft). The Power Injector has no On/Off power switch. The Power Injector
receives power as soon as AC power is applied. For more information, see
11. Verify the behavior of the AP-6511 Access Point LEDs. For more information, see
12. The AP-6511 is ready to configure. For information on basic Access Point device configuration, see
Access Point Configuration
.
AP-6511 Access Point
Power Injector System
LED Indicators
.
Basic
.