Ultra Wash; Soil Removal System; Featuring Smartwash™ Cycle And Turbozone™ Wash Option; Start-Up Guide - Kenmore 665.1348 Series Use & Care Manual

®
The ULTRA WASH Soil Removal System gives you
sparkling clean dishes, while using less energy and time.
The ULTRA WASH ® Soil Removal System includes:
A Triple Action Filtration system that intermittently
■
filters soil from the wash water, thus eliminating the
need to scrape dishes.
smartwash
How the ™ cycle works
When the smartwash™ cycle is selected, it saves energy
and water by adjusting the wash cycle as needed.
Sensors detect the size of the dish load, the soil level,
■
and the water temperature in the dishwasher.
■ Sensors automatically adjust the temperature and the
amount of water used for the load.
This dishwasher will automatically calibrate the sensor
approximately once a year to your water quality.
Before using your dishwasher, remove all packaging materials. Read this entire Use and Care Guide. You will find
important safety information and useful operating tips.
1. Rinse aid is essential for good drying. Be sure to fill the
dispenser before you use your new dishwasher. Each
filling will last about 1 to 3 months depending on your
usage.
2. Scrape large food soil and hard items (toothpicks or
bones) from dishes.
3. Properly load the dishwasher. (See "Dishwasher
Loading.") Load dishes with space in between so water
will reach the soiled surfaces. Make sure nothing keeps
the spray arm(s) from spinning freely.

ULTRA WASH

®

Soil Removal System

Featuring
smartwash
TURBOZONE™ wash option

START-UP GUIDE

Using Your New Dishwasher

®
■ An ULTRA WASH optical soil sensor that detects soil
level and detergent quantity appearing in the wash
water and adjusts the cycles as needed.
An Automatic Temperature Control (ATC) that ensures
■
the proper water temperature for the selected wash
cycle, dish load size, and soil level of the load.
™ cycle and
IMPORTANT: The very first wash cycle after installation in
your home will be adjusted to include an additional 2
rinses for optical soil sensor calibration. For proper
calibration, the first cycle should not be interrupted. If this
calibration cycle is canceled or stopped before the Clean
light comes on at the end of the cycle, the next wash cycle
will repeat this sensor calibration.
How the T Z ™ wash option works
URBO ONE
When the T Z ™ option is selected, it provides a
URBO ONE
concentrated wash to a specific zone in the back of the
lower dish rack for large, hard-to-clean dishes.
4 rotating spray jets on the T
■
periodically activated at the back of the tub throughout
the wash cycle.
Intensified cleaning is provided only to this specific
■
wash area, allowing you to gently clean the rest of the
dish load.
4. Add detergent. Always use a high-quality brand
detergent. (See "Dishwasher Use.")
MAIN WASH
5. Push door firmly closed. The door latches
automatically.
6. Run hot water at the sink nearest your dishwasher until
the water is hot. (See "Dishwasher Efficiency Tips.")
Turn off water.
Z ™ manifold are
URBO ONE
PRE-
WASH
7