Kenmore 665.1348 Series Use & Care Manual page 17

T Z ™ wash option
URBO ONE
Select this option to activate the T
and provide intensified water spray to the back of the
lower dish rack. The T
URBO
concentrated wash action to pans, casseroles, etc. with
tough food soil.
This option may add heat and wash time to the cycle.
NOTE: T Z ™ is an option with the SMART
URBO ONE
WASH™, Pots Pans, and Normal Wash cycles.
IMPORTANT:
■ Load pans, casserole dishes, etc. facing the
T Z ™ spray jets in the back of the lower dish
URBO ONE
rack. Tip items toward the rear of the dish rack to
maximize coverage. Only one row of items may face
the T Z ™ spray jets. Stacking, overlapping, or
URBO ONE
nesting items will keep the T
from reaching all of the surfaces.
To maximize spray coverage, avoid placing silverware
■
basket or other items to interfere with the T
spray jet rotation.
Turn the T Z ™ wash option off if not loading
■
URBO ONE
items for this option. Always use heavy soil detergent
fill recommendation with T
(See "How much detergent to use" in "Detergent
Dispenser" section.)
Side view of T
High Temp
Select this option to increase the water temperature during
the wash portions of the cycle. High Temp wash raises the
water temperature to 145ºF (63ºC), in the main wash.
Heating the water helps improve washing results. High
Temp wash is useful when loads contain tough food soil.
This option may add heat and wash time to the cycle.
NOTE: High Temp wash is an option with the SMART
WASH™, Pots Pans, and Normal Wash cycles.
Z ™ spray jets
URBO ONE
Z ™ wash option provides a
ONE
Z ™ spray jets
URBO ONE
URBO
Z ™ wash option.
URBO ONE
Z ™ wash area
URBO ONE
Sani Rinse
Select this option to raise the water temperature in the final
rinse to approximately 155°F (68°C). Sani Rinse adds heat
and time to the cycle. This high temperature rinse sanitizes
your dishes and glassware in accordance with NSF/ANSI
Standard 184 for Residential Dishwashers. Certified
residential dishwashers are not intended for licensed food
establishments.
NOTE: Sani Rinse is an option with SMART WASH™, Pots
Pans, and Normal Wash cycles. Only these sanitization
cycles have been designed to meet the NSF/ANSI
requirements.
Heated Dry
The Heated Dry option in combination with rinse aid will
give you excellent drying results. The energy to use Heated
Dry costs pennies per cycle. Heated Dry is on when the
light is lit on the Heated Dry button. Be sure to load plastic
Z ™
ONE
items in the upper rack to avoid damage.
You may turn off the Heated Dry option by pressing
HEATED DRY so that the light goes off. However, you will
have items in your dish load that will not be dry at the end
of the cycle.
NOTE: The Heated Dry option is used in all cycles except
Fast Wash and Quick Rinse.
Lock On
Use the Lock On to avoid unintended use of the
dishwasher between cycles. You can also use the lock
feature to avoid unintended cycle or option changes
during a cycle.
When Lock On is lit, all buttons are disabled.
NOTE: The dishwasher door can be opened while the
controls are locked. However, the lock must be turned off
and the Start/Resume button pressed to resume the cycle.
To turn on the Lock
Press and hold HEATED DRY for 4 seconds. Lock On
glows.
If you press any pad while your dishwasher is locked, the
light flashes 3 times.
NOTE: If the Heated Dry option is selected, the light will
temporarily turn off until Lock On glows.
To turn off the Lock
Press and hold HEATED DRY for 4 seconds. The light turns
off.
17