Transmitter; Preparing The Transmitter; Throttle Stick; Elevator Stick - Merlin CESSNA T-206 Instruction Manual

Transmitter

The Merlin Transmitter is an advanced controller designed for the beginner to be easy to use and tune. You will need
to follow the steps below to ensure you prepare the controller correctly for use and understand the adjustment possi-
bilities available.

Preparing the transmitter

Preparing the transmitter
8
2
5
16
7
13

Throttle Stick

1
2

Rudder Stick

2
1
4
Open the battery hold-
ing tray to expose the
empty battery slots.
Insert 8 AA batteries
into the marked spaces.
Please note the correct
direction of the batteries
1
4
6
3
1. Push the stick
forward to increase
propeller speed
2. Pull the stick
backwards to
decrease propeller
speed
1. Push the stick left to
turn left, rudder
moves left
2. Push the stick right
to turn right, rudder
moves right
1.
2.
3.
4.
14 10 11
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
15 12 9

Elevator Stick

1.
1
2.
2

Aileron Stick

1.
2.
2
1
Insert the aerial into the
hole and turn clockwise
until it is tightly secured.
Make sure you never over
extend the aerial as this
will cause it to break.
Aerial
Throttle Trim
Aileron Trim
Elevator Trim
Throttle/Rudder Stick
Aileron/Elevator Stick
Power Switch
Battery level indicator
Rudder reverse switch
Aileron reverse switch
Throttle reverse switch
Elevator reverse switch
Frequency Crystal
Rate Switch (see page 13)
Aileron/Elevator Mixer
Switch (see page 13)
Rudder Trim
Push the stick forward to
lower the nose,
elevator moves down
Pull the stick backwards
to raise the nose,
elevator moves up
Push the stick left to roll left,
left hand elevator moves up
and right side down
Push the stick right to roll
right, left hand elevator
moves down and right side
up