Transmitter; Preparing The Transmitter; Throttle Stick; Elevator Stick - Merlin Condor 1380 Instruction Manual

Transmitter

The Merlin MTX-41 Transmitter is an advanced controller designed for the beginner to be easy to use and tune. You will need to follow the steps
below to ensure you prepare the controller correctly for use and understand the adjustment possibilities available.

Preparing the transmitter

8
2
5
13

Throttle Stick

1
2

Rudder Stick

1.
2.
2
1
Open the battery holding tray to
expose the empty battery slots.
Insert 8 AA batteries into the
marked spaces. Please note the
correct direction of the batteries
Incorrect battery insertion could
lead to damage
1
9 10 11 12
1. Push the stick forward
to increase propeller
speed
2. Pull the stick back-
wards to decrease
propeller speed
Push the stick left to turn
left, rudder moves left
Push the stick right to
turn right, rudder moves
right
1. Aerial
2. Throttle Trim
3. Rudder Trim
4. Elevator Trim
5. Throttle Stick
6. Rudder/Elevator Stick
7. Power Switch
8. Battery level indicator
9. Not Used
4
10. Rudder reverse switch (labelled AIL)
11. Throttle reverse switch
6
12. Elevator reverse switch
13. Frequency Crystal
3
7

Elevator Stick

1.
1
2.
2
4
Insert the aerial into the hole and
turn clockwise until it is tightly
secured.
Make sure you never over extend
the aerial as this will cause it to
break.
Push the stick forward to
lower the nose, elevator
moves down
Pull the stick backwards to
raise the nose, elevator
moves up