Dhcp Server - Atlantis Land Network Router User Manual

I-Fly Wireless Router ADSL
IP Address: Default at 192.168.1.254.
This is the device IP address in LAN site. If you plan to change it to another IP address to a different
range of IP subnet. Please make sure your PC is also located at the same IP subnet. Otherwise, you may
not be able to access the ADSL Router.
Subnet Mask: Default at 255.255.255.0.

DHCP Server

Check to enable the ADSL Router to distribute IP Addresses, subnet mask and DNS setting to computers.
If you do not check to disable the ADSL Router to distribute IP addresses to the local network, remember
to specify a static IP address, subnet mask, and DNS setting for each of your local computers. Be careful
not to assign the same IP address to different computers.
If there is already a DHCP server on your LAN, you should disable the router's DHCP server
function in order to avoid possible conflicts.
DHCP address pool selection: Select System Allocated if you want the device to allocate the local IP
network address pool automatically. Select User Defined if you would like to set your own IP addresses
for distribution to PCs, and then enter your settings below.
User Defined Start Address: Enter the starting address of this local IP network address pool. The pool is
a piece of continuous IP address segment. The default value is 192.168.1.100.
User Defined End Address: Enter the end address of this local IP network address pool. The default
value is 192.168.1.199.
With this case, the local computer will get an IP address randomly located at this range, from
192.168.1.100 to 192.168.1.199.
Lease Time: Set the lease time you required.
36