Page 3
COPYRIGHT The Atlantis Land logo is a registered trademark of Atlants Land SpA. All other names mentioned mat be trademarks or registered trademarks of their respective owners. Subject to change without notice. No liability for technical errors and/or omissions. Copyright 2002 by this company.
AtlantisLand I-Storm Lan Router ADSL 1.1 I NTRODUCTION TO 1. 2 P RODUCT EATURES 1.3 P ACKAGE ONTENTS AND 1.4 H ARDWARE NDICATORS Front Panel ... 6 LED Indicators... 7 Rear Panel ... 7 1.5 H ARDWARE NSTALLATION 1.6 TCP/IP C ONFIGURATION Windows 95/98/ME ...
I-Storm Lan Router 1.1 Introduction to Ethernet Router The I-Storm Lan Router ADSL is optimized to address the growing demand for high-speed Internet access. With both a USB 1.1-complient interface and an IEEE 802.3-complient Ethernet interface, it provides the widest array of connectivity options without relaying on host PC drivers. The I-Storm Lan Router ADSLis an “always-on”...
Page 7
Bridge / Router Protocols • Ethernet to ADSL self learning Transparent Bridging (IEEE 802.1D ) • 128 MAC Address support • RIPv2(backward compatible route table) • Static IP Routing(Configurable route table) • DHCP server (configurable and supports up to 254 addresses) •...
AtlantisLand I-Storm Lan Router ADSL • Simultaneous operation with Ethernet Interface • Host driver for Win98se,2K,Me,XP HTTP Web-Based Management • Local Firmware upgrade via FTP or Web • Remote Firmware upgrade via FTP client • Customizable Web pages • WAN and LAN side connection statistics •...
LED Indicators The LED Indicators read as follows: POWER READY ADSL LINK(4) ACT(4) Rear Panel The rear panel of the Router provides access to the DC power adapter, one USB connection, four LAN connections, one WAN connection and power on/off switch. INFORMATION Steady red light indicates the router is powered on.
AtlantisLand I-Storm Lan Router ADSL PORT 1 POWER (jack) 2 USB 3 4 *LAN (RJ-45) 4 LINE (RJ-11) 1.5 Hardware Installation Power on Connect the Adapter to power inlet and turn the power switch on, this product will enter a self-test phase.
Page 11
4. Now, you have two setting methods: A. Get IP from Router...
AtlantisLand I-Storm Lan Router ADSL B. Configure IP manually. Select Specify an IP address on the IP address tab. The default IP address of Router is 192.168.1.254. So please use 192.168.1.x (X is between 1 and 253) for IP address field and 255.255.255.0 for Subnet Mask field.
B. Configure IP Address manually. Select Use the following IP address. The default IP address of Router is 192.168.1.254. So please use 192.168.1.X (X is between 1 and 253,) for IP address field and 255.255.255.0 for Subnet Mask field. In the Default Gateway field, add the IP address of the Router (default IP is 192.168.1.254) Select Use the following DNS server addresses.
AtlantisLand I-Storm Lan Router ADSL 1.8 CONFIGURING ADSL ROUTER The Router offers a web-based (HTML) graphical user interface allowing users to manage the Router using a standard browser software such as Netscape Navigator or Microsoft Internet Explorer. Accessing the Web Manager Launch the Web browser.
1.10 ROUTER CONFIGURATION The WAN configuration page allows user to set the configuration for the WAN/ADSL ports. 1. Per VC Settings: Under Per VC Setting, it provides the configurations for IP address, Subnet Mask, Gateway and VPI/VCI. Current firmware supports eight PVCs.To switch between the PVCs, please choose the options of virtual circuit and click on the Submit button to switch over.
Page 16
AtlantisLand I-Storm Lan Router ADSL 5. PPP Configuration: The current release supports multiple PPP sessions per PVC. The PPP configuration in the WAN configuration page is for the first PPP session for each PVC. The predefined PPP Account Name (Account ID) is “Simple PPP Account 0” for PVC0 and predefined PPP Connection Name is “Simple PPP Session 0”...
ADSL modem’s WAN IP) the IGMP report to ADSL WAN side, include all PVCs. The same case is for IGMP leave packet. Not necessary to relay multicast routing between two ADSL PVCs or two interfaces in LAN side. Special purpose multicast packet (such as RIP 2 packet) should run without interference. Table 6-1.
AtlantisLand I-Storm Lan Router ADSL 2. Encapsulation: 1483 Bridged IP LLC 3. Bridged: Disabled 4. NAT Configuration: Dynamic NAPT Please see scenario 2: Router Mode Configuration with Dynamic IP in Appendix for more detail configuration. 8.2 Static IP for WAN IP (RFC 1483 ROUTED) Following settings are necessary when working under this mode: 1.
3. Bridged: Disabled 4. PPP User Name: Provided by ISP 5. PPP password: Provided by ISP 6. NAT Configuration: Dynamic NAPT Please see scenario 5: Router Mode Configuration PPPoE in Appendix for more detail configuration. 8.5 Classical IP over ATM ( RFC 1577) Following settings are necessary when working under this mode: 1.
AtlantisLand I-Storm Lan Router ADSL Use the Default IP Address. • The Router comes with a preset default IP address setting of 192.168.1.254 for the LAN port. There are two ways to use this default IP address, you can manually assigned an IP address and subnet mask for each PC on the LAN or you can instruct the Router to automatically assign them using DHCP.
the LAN client and the WAN host will indicate their MSS during the TCP connection handshake. The default value is 1432. • Automatic Reconnect: When it is checked, it will maintain the PPP connection all the time. If the ISP shut down the PPP connection, it will automatically reconnect PPP session. •...
Page 22
AtlantisLand I-Storm Lan Router ADSL Interface: This field allows the user to choose specific WAN Interface (PVC or PPP Session) for NAT Session. NAT Session Name Status will be displayed at the bottom of this page to show all the Session Names with its WAN Interface. Click the link Go back to NAT Configuration to the NAT configuration page.
Interface: This field allows the user to choose specific WAN Interface (PVC or PPP Session) for NAT Session. NAT Session Name Status will be displayed at the bottom of this page to show all the Session Names with its WAN Interface. Click the link Go back to NAT Configuration to the NAT configuration page.
AtlantisLand I-Storm Lan Router ADSL Public Port: This field allows the user to enter the port number of the Public Network. Private Port: This field allows the user to enter the port number of the Private Network. In most cases, the private port number is same as public port number. Host IP Address: This field allows the user to enter the private network IP address for the particular sever.
DNS Configuration Domain Name Service (DNS) is a service used on the Internet for resolving fully qualified domain names (FQDN) to their Internal Protocol (IP) address. You can type the preferred DNS server IP address, Alternative DNS server IP address that provided by ISP or automatically assigned by ISP. Click submit and save settings to save your setting.
AtlantisLand I-Storm Lan Router ADSL Save Settings The Save Settings page allows users to save the new configuration to the flash and reboot the system. When you change all setting, you must click save settings and click submit. The Router will save settings and software reset router for about 20 seconds.
1.11 ROUTER ADMIN PRIVILEGE: The links under Admin Privilege are only to be accessed and configured, when it is login with administrator login name and password. WAN Status The WAN Status page shows the information and status of WAN PVCs. The DHCP Release and Renew allows the users to release and renew the WAN IP address in the WAN DHCP Client Enabled (dynamic) mode.
AtlantisLand I-Storm Lan Router ADSL All user-defined routes retained in the CPE memory, regardless if they are already in the Routing Table, are displayed on the same Route Table page. All user defined route entries kept in the CPE memory during run time are saved to flash when the user chooses to save and reboot the CPE.
Aging Timeout: This field allows the user to enter the update period for the MAC table. ADSL Configuration The ADSL Configuration page allows users to set the configuration for ADSL protocols. Trellis: This field allows the user to enable or disable the Trellis Code. By default, it is always enabled.
AtlantisLand I-Storm Lan Router ADSL Garbage Timeout: This field allows the user to enter the Garbage timer in second. This timer specifies how long the expired and invalidated routes are kept in the Internal RIP Route Table before it is removed from it. (Default = 300 seconds) RIP Per Interface Configuration The RIP Per Interface Configuration page allows the user to set the configuration for each Interface (PVCs, PPP Sessions, USB and LAN).
The User Password Configuration page allows the user to set the password for the user. Miscellaneous Configuration The Miscellaneous Configuration allows users to set all the miscellaneous configurations. HTTP Server Access: This field allows the user to configure the Web pages can be accessed from: All: When this field is checked, it allows both WAN and LAN access to the Web pages.
AtlantisLand I-Storm Lan Router ADSL For the PPP connect on WAN access, the PPP will be automatically reconnected when an URL is entered in the browser (packet interested in going out the WAN). For the Automatic Reconnect, it will reconnect the PPP session whenever it is terminated by ISP. PPP Half Bridge: When the PPP Half Bridge is enabled, only one PC is able to access the Internet, and the DHCP server will duplicate the WAN IP address from the ISP to the local client PC.
Network Code Image Update The Network Code Image Update page allows users to upgrade the image code from the remote FTP server. System Log The System Log page shows the events triggered by the system.
If you have any problems with the ADSL Router, please consult this manual. If you continue to have problems you should contact the dealer where you bought this ADSL Router. If you have any other questions you can contact the Atlantis Land company directly at the following address:...
APPENDIX: ISP ADSL Ethernet Router Configuration Scenario 1: Bridge Mode Configuration (with PPPoE Client) WAN Configuration Default Gateway VC Setting Static IP Address Subnet Mask Encapsulation Bridged IGMP PPP Service Name PPP User Name PPP password DHCP Client Host name Virtual Circuit LAN Configuration LAN IP...
Page 36
AtlantisLand I-Storm Lan Router ADSL Misc Configuration WAN side HTTP server FTP server TFTP server HTTP server port DMZ Host IP DNS Proxy DHCP Relay IGMP proxy PPP reconnect on WAN access Disabled Disabled Disabled Disabled 0.0.0.0 Enabled Disabled Disabled Disabled...
Scenario 2: Router Mode Configuration with Dynamic IP WAN Configuration Default Gateway VC Setting Static IP Address Subnet Mask Encapsulation Bridged IGMP PPP Service Name PPP User Name PPP password DHCP Client Host name Virtual Circuit LAN Configuration LAN IP LAN subnet mask DHCP server DHCP address pool selection...
Page 38
AtlantisLand I-Storm Lan Router ADSL HTTP server port DMZ Host IP DNS Proxy DHCP Relay IGMP proxy PPP reconnect on WAN access Disabled 0.0.0.0 Enabled Disabled Disabled Disabled...
Scenario 3: Router Mode Configuration with Static IP WAN Configuration Default Gateway VC Setting Static IP Address Subnet Mask Encapsulation Bridged IGMP PPP Service Name PPP User Name PPP password DHCP Client Host name Virtual Circuit LAN Configuration LAN IP LAN subnet mask DHCP server DHCP address pool selection...
Page 40
AtlantisLand I-Storm Lan Router ADSL DMZ Host IP DNS Proxy DHCP Relay IGMP proxy PPP reconnect on WAN access Disabled 0.0.0.0 Enabled Disabled Disabled Disabled...
Scenario 4: Router Mode PPPoA Configuration (RFC2364) WAN Configuration Default Gateway VC Setting Static IP Address Subnet Mask Encapsulation Bridged IGMP PPP Service Name PPP User Name PPP password DHCP Client Host name Virtual Circuit LAN Configuration LAN IP LAN subnet mask DHCP server DHCP address pool selection User defined start address...
Page 42
AtlantisLand I-Storm Lan Router ADSL DMZ Host IP DNS Proxy DHCP Relay IGMP proxy PPP reconnect on WAN access 0.0.0.0 Enabled Disabled Disabled Enabled...
Scenario 5: Router Mode PPPoE Configuration (RFC2516) WAN Configuration Default Gateway VC Setting Static IP Address Subnet Mask Encapsulation Bridged IGMP PPP Service Name PPP User Name PPP password DHCP Client Host name Virtual Circuit LAN Configuration LAN IP LAN subnet mask DHCP server DHCP address pool selection User defined start address...
Page 44
AtlantisLand I-Storm Lan Router ADSL DMZ Host IP DNS Proxy DHCP Relay IGMP proxy PPP reconnect on WAN access Disabled 0.0.0.0 Enabled Disabled Disabled Enabled...
Scenario 6: Router Mode Configuration with Classical IP over ATM (RFC1577) WAN Configuration Default Gateway VC Setting Static IP Address Subnet Mask Encapsulation Bridged IGMP PPP Service Name PPP User Name PPP password DHCP Client Host name Virtual Circuit LAN Configuration LAN IP LAN subnet mask DHCP server...
Page 46
AtlantisLand I-Storm Lan Router ADSL TFTP server HTTP server port DMZ Host IP DNS Proxy DHCP Relay IGMP proxy PPP reconnect on WAN access Disabled Disabled 0.0.0.0 Enabled Disabled Disabled Disabled...
Need help?
Do you have a question about the I-Storm Lan Router ADSL A02-RA2 ME01 and is the answer not in the manual?
Questions and answers