Table of Contents
Advertisement
I-Fly Wireless Router ADSL
Enabled? : Select Yes if you want to enable the settings of this VC or select No if you want to disable
the settings of this VC.
VPI: Consult the telephone company to get the Virtual Path Identifier (VPI) number. The default value is
0.
VCI: Consult the telephone company to get the Virtual Channel Identifier (VCI) number. The default
value is 32.
Static IP Address: Enter the information provided by your ISP.
Subnet Mask: Enter the information provided by your ISP.
ATM
Service Category: Select UBR or CBR.
Bandwidth: Enter the bandwidth.
ENCAPSULATION
There are eleven ways ― PPPoE VC-Mux, PPPoE LLC, PPPoE None, PPPoA VC-Mux, PPPoA LLC,
1483 Bridged IP VC-Mux, 1483 Bridged IP LLC, 1483 Routed IP VC-Mux, 1483 Routed IP LLC,
Classical IP over ATM, Native ATM ― for the device to have a public IP address and then to access
Internet. You have to check with your ISP about which way is adopted.
BRIDGE
If you set this device to be bridge mode, select Enable; if not, please select Disable.
IGMP
You can Enable or Disable this function.
PPP
If your encapsulation is set to be PPPoE or PPPoA, the following fields must be entered.
Service Name: This item is for identification purpose. If it is required, your ISP will provide you the
information. Maximum input is 31 alphanumeric characters.
Username: Enter the username provided by your ISP.
Password: Enter the password provided by your ISP.
Disconnect Timeout
line for a predetermined period of time. You can input any number from 0 to 32767. The default value is
0 seconds.
Authentication: Default at "Auto".
Automatic Reconnect: Check to enable this device to automatically re-establish the PPPoE session when
disconnected by ISP.
DHCP
34
seconds: Auto-disconnect the ADSL Router when there is no activity on the
Advertisement
Table of Contents
