Detect - Dahua NVR6000 Series User Manual

3.5.6 Detect

Go to Detect Menu
In the main menu, from Setting to Detect, you can see motion detect interface. See Figure
3-71.There is three detection types: motion detection, video loss, camera masking.

The video loss has no detection region and sensitivity setup and camera masking has no
detection region setup.

You can see motion detect icon if current channel has enabled motion detect alarm.

You can drag you mouse to set motion detect region without Fn button. Please click OK
button to save current region setup. Right click mouse to exit current interface.
Motion Detect
Detection menu is shown as below. See Figure 3-71.

Event type: From the dropdown list you can select motion detection type.

Channel: Select a channel from the dropdown list to set motion detect function.

Enable: Check the box here to enable motion detect function.

Region: Click select button, the interface is shown as in Figure 3-72. Here you can set
motion detection zone. There are 396(PAL)/330(NTSC) small zones. The green zone is
current cursor position. Grey zone is the motion detection zone. Black zone is the disarmed
zone. You can click Fn button to switch between the arm mode and disarm mode. In arm
Figure 3-69
Figure 3-70
58