Nvr 724 Series - Dahua NVR6000 Series User Manual

Please refer to the following sheet for detailed information.
SN Name
1 Power button
2 System HDD
Indicator light
3 Alarm indicator
light
4 Network
indicator light
5 USB port
6 16 HDD slot
After you remove the front panel, you can see there are 16 HDDs. From the left to the right and
from the top to the bottom, it ranges from 1~4, 5~8, 6~12, 13~16. See Figure 2-3.
You can see there are two indication lights on the HDD bracket.

The power indication light is at the top. The light is yellow after you connected the device to
the power.

The read-write indication light is at the bottom. The blue light flashes when system is reading
or writing the data.

2.1.2 NVR 724 Series

The front panel is shown as in Figure 2-4.
Function
Press it once to turn on the device.
Press it for a long time to turn off the device (Usually we do not
recommend).
Press power button for a long time or pull out the power cable may
result in device auto restart.
The blue light flashes when system is reading or writing the system
HDD.
In the system HDD, there are device important configuration file,
factory default configuration file, device initial boot up data.
The alarm indicator light becomes on once an alarm occurred. It
becomes on via the software detection. The alarm includes local
alarm, no disk and etc.
The network indicator light is blue and it flashes when you connect
the device to the network.
/
/
Figure 2-3
7