Web Operation; General Introduction; Preparation; Log In - Dahua NVR6000 Series User Manual

5 WEB OPERATION

5.1 General Introduction

The device web provides channel monitor menu tree, search, alarm setup, system setup, PTZ
control and monitor window.

5.1.1 Preparation

Before log in, please make sure:

PC and NVR connection is OK.

You have set PC IP address, NVR IP address, subnet mask and gateway. (Please set the IP
address of the same section for the PC and NVR. Please input corresponding gateway and
subnet mask if there are routers.) This series product max supports 4 network adapters. The
default setup is eth1:192.168.1.108, eth2:192.168.1.101, eth3:192.168.1.102 and
eth4:192.168.1.103.

Use order ping ***.***.***.***(NVR IP address) to check connection is OK or not.

5.1.2 Log in

Open the IE and then input the NVR IP address in the address column.
For example, if your NVR IP address is 10.10.3.16, then please input http:// 10.10.3.16 in IE
address column. See Figure 5-1.
System pops up warning information to ask you whether install webrec.cab control or not. Please
click yes button.
If you can't download the ActiveX file, please modify your settings as follows. See Figure 5-2.
Figure 5-1 IE Interface
Input IP
address here.
81