Image Adjustment - Christie LX1750 Network Manual

Chapter 4 Controlling the Projector

Image adjustment

This function is to adjust the projected picture image and save the image mode. To store
the adjusted value, click Store, and to load the adjusted value, click Load.
Item Description
Contrast ................................. Adjusts picture contrast.
Brightness ............................ Adjusts picture brightness.
Color ......................................... Adjusts picture color satura-
Tint ............................................ Adjusts picture hue. (0~ 63)
Color temp. .......................... Sets a color temperature
White balance
Red, Green, Blue .......... Adjusts each white balance
* When changing the value of the white balance,
the color temp. indicates "Adj."
Offset
Red, Green, Blue .......... Adjusts each offset respec-
Auto picture control ..... Sets auto picture control
Advanced color ................ Applies improved color
Sharpness ............................. Adjusts picture sharpness.
Gamma ..................................... Adjusts brightness of darker
Noise reduction .................Switches noise reduction mode. (ON, OFF)
Progressive .................................. Switches progressive mode. (OFF, ON, Film)
Reset.........................................Resets the Image adjustment to previous levels.
Store ......................................... Stores the Image adjustment values. Select an item [Image1 - Image10] from
Load Image mode .......... Loads the Image mode. Select an image mode from the pull-down menu
Input source
Image mode Video Computer
Standard
Cinema
Real
Dynamic
Image1 - 10
36
(0~ 63)
(0~ 63)
tion. (0~ 63)
mode. (X Low, Low, Mid, High,
Adj.)
respectively. (0~ 63)
tively. (0~ 63)
level. (OFF, L1, L2)
adjustment with yellow
light controller. (Auto, OFF)
(0~ 31)
part of the picture. (0~ 15)
the pull-down menu and click Store.
and click Load. There may not be available mode depending on the input
mode as shown in the table left.
* When Edge blending is set to "ON", Auto picture control and
Advanced color are disabled.
* When Color matching is set to "ON", Auto picture control,
Advanced color, Color temp., White balance and Offset are
4 4
disabled.
*
4
*
4
✐ The checkmark indicates the image mode is available in
4 4
4 4
the selected input source. The error message appears when
selecting the disabled image mode indicated with "*".
LX1750 Network User Manual
020-000639-01 Rev.1 (11-2013)