Image Adjustment - Christie LWU505 User Manual

Image adjustment

This function is to adjust the projected picture image and save the image mode. To store
the adjusted value, click Store button, and to load the adjusted value, click Load button.
Item Description
Contrast .............................. Adjusts picture con-
trast. (0~ 63)
Brightness ......................... Adjusts picture bright-
ness. (0~ 63)
Color...................................... Adjusts picture color
saturation. (0~ 63)
Tint ......................................... Adjusts picture hue.
(0~ 63)
Iris............................................ Switches iris mode to
increase the contrast
intensity. (ON, OFF)
Color temp........................ Sets a color temperature
mode. (X Low, Low, Mid,
High, Adj.)
White Balance
Red, Green, Blue ..... Adjusts each white
balance respectively.
(0~ 63)
* When changing the value of the
white balance, the color temp.
indicates "Adj."
Sharpness................................Adjusts picture sharpness. (0~ 31)
Gamma ........................................ Adjusts brightness of darker part of the picture. (0~ 15)
Noise reduction.....................Switches noise reduction mode (ON, OFF)
Progressive.......................................Switches progressive mode (OFF, ON, Film)
Reset............................................Resets the Image adjustment to previous levels.
Store............................................Stores the Image adjustment values. Select an item [Image1 - Image10]
from the pull-down menu and click Store button.
Load image mode .............Loads the Image mode. Select an image mode from the pull-down menu
and click Load button. There may not be available mode depending on the
input mode as shown in the table left.
Input source
Image mode Video Computer
Dynamic
Standard
Natural *
Cinema *
Real *
Image1 - 10
LWU505 Network User Manual
020-000376-01 Rev.1 (01-2011)
The mark " " means that the available image mode in the
selected input source. The error message appears when
selecting the disabled image mode indicated with "*".
Control
37