Flow Of Installation; Notice About Installing Software Cd-Rom - Christie LX1750 Network Manual

Flow of installation

To use the projector via the networks, follow the setup procedures below.
STEP 1
Connect the LAN and set the configuration.
Decide depending on the LAN environment.
Detailed LAN configurations need to be done with a browser later.
First, complete the Wired LAN connection between computers and projec-
tors, then start browser configurations.
STEP 2
Network Configuration has completed.
Follow each chapter to operate the projector.
■ Operate and manage the projector ➔ "4. Controlling the projector" (pp.31-45)
STEP 3 Install the Software on computers.
Install the software recorded in CD-ROM on each computer which will be
operated. Refer to the user manual of PJ Network Manager.

Notice about installing Software CD-ROM

It is available for controlling and setting of the projector by using the web browser without
installing any software. So it is not required to install the software into your computer.
For PJ Network Manager function, it is required to install the software. Please see the user
manual of "PJ Network Manager Function".
LX1750 Network User Manual
020-000639-01 Rev.1 (11-2013)
➔ "2. Setup Procedures" (pp.11–16).
➔ "3. Basic setting and operation" (pp.17–30).
➔ "Power Control and status check" (p.32)
➔ "Control" (pp.34-36)
➔ "PC adjustment" (p.37)
➔ "Setting up the projector" (pp.38-42)
➔ "Projector information" (pp.43-45)
Flow of installation
9