Lcd Module Removal; Vibrate Motor Removal; Battery Contacts Removal - Multitone FLA 872 Technical Manual

TLA 852/FLA 872
5.5.4

LCD Module Removal

a) Remove the Board Assembly from the case (see paragraphs 5.5.1 and 5.5.2)
and separate the Decoder Board from the Radio Board (see paragraphs 5.5.3.,
a) through c)).
b) Release the two module pins from the holes in the Decoder Board and carefully
fold the module away from the board to get access to the flexible cable.
c) Use the Anti-static Workstation and the correct soldering tools to disconnect the
flexible cable from the board.
5.5.5

Vibrate Motor Removal

a) Remove the Board Assembly from the case (see paragraphs 5.5.1 and 5.5.2)
and separate the Decoder Board from the Radio Board (see paragraphs 5.5.3.,
a) through c)).
b) Use the Anti-static Workstation and the correct soldering tools to disconnect the
two wires from the board.
c) Use a screwdriver to lever the Vibrate Motor carefully from the clip.
5.5.6

Battery Contacts Removal

a) Remove the Board Assembly from the case (see paragraphs 5.5.1 and 5.5.2).
b) Pull the contacts out of their slots in the Case Back.
Page 5 - 6 TM1205 Issue 2