Interface Status Summary Screen - ZyXEL Communications USG40 User Manual

Table 28 Dashboard > Extension Slot
LABEL
Device
Status

5.2.11 Interface Status Summary Screen

Interfaces per ZyWALL/USG model vary.
Figure 82 Dashboard > Interface Status Summary
This table describes the fields in the above screen.
Table 29 Dashboard > Interface Status Summary
LABEL
Name
Chapter 5 Dashboard
DESCRIPTION
This field displays the name of the device connected to the extension slot (or
none if no device is detected). For an installed SEM (Security Extension Module)
card, this field displays what kind of SEM card is installed.
SEM-VPN - The VPN accelerator. The SEM-VPN provides 500 Mbps VPN
throughput, 2,000 IPSec VPN tunnels, and 750 SSL VPN users.
SEM-DUAL - accelerator for both VPN and UTM. The SEM-DUAL provides the
benefits of the SEM-VPN and increases the maximum anti-virus and IDP traffic
throughput from 100 Mbps to 400 Mbps.
USB Flash Drive - Indicates a connected USB storage device and the drive's
storage capacity.
The status for an installed WLAN card is none. For cellular (mobile broadband)
interfaces, see Section 6.10 on page 115
installed SEM (Security Extension Module) card, this field displays one of the
following:
Active - The SEM card is working properly.
Ready to activate - The SEM was inserted while the ZyWALL/USG was
operating. Restart the ZyWALL/USG to use the SEM.
Driver load failed - An error occurred during the ZyWALL/USG's attempt to
activate the SEM card. Make sure the SEM is installed properly and the
thumbscrews are tightened. If this status still displays, contact your vendor.
Ready - A USB storage device connected to the ZyWALL/USG is ready for the
ZyWALL/USG to use.
Unused - The ZyWALL/USG is unable to mount a USB storage device connected
to the ZyWALL/USG.
DESCRIPTION
This field displays the name of each interface.
ZyWALL/USG Series User's Guide
94
for the status that can appear. For an