ZyXEL Communications USG40 User Manual page 95

Table 29 Dashboard > Interface Status Summary
LABEL
Status
HA Status
Zone
IP Addr/Netmask
IP Assignment
Action
Chapter 5 Dashboard
DESCRIPTION
This field displays the current status of each interface. The possible values
depend on what type of interface it is.
For Ethernet interfaces:
Inactive - The Ethernet interface is disabled.
Down - The Ethernet interface does not have any physical ports associated with
it or the Ethernet interface is enabled but not connected.
Speed / Duplex - The Ethernet interface is enabled and connected. This field
displays the port speed and duplex setting (Full or Half).
For cellular (mobile broadband) interfaces, see
status that can appear.
For the auxiliary interface:
Inactive - The auxiliary interface is disabled.
Connected - The auxiliary interface is enabled and connected.
Disconnected - The auxiliary interface is not connected.
For PPP interfaces:
Connected - The PPP interface is connected.
Disconnected - The PPP interface is not connected.
If the PPP interface is disabled, it does not appear in the list.
For WLAN interfaces:
Up - The WLAN interface is enabled.
Down - The WLAN interface is disabled.
This field displays the status of the interface in the virtual router.
Active - This interface is the master interface in the virtual router.
Stand-By - This interface is a backup interface in the virtual router.
Fault - This VRRP group is not functioning in the virtual router right now. For
example, this might happen if the interface is down.
n/a - Device HA is not active on the interface.
This field displays the zone to which the interface is currently assigned.
This field displays the current IP address and subnet mask assigned to the
interface. If the IP address is 0.0.0.0/0.0.0.0, the interface is disabled or did not
receive an IP address and subnet mask via DHCP.
If this interface is a member of an active virtual router, this field displays the IP
address it is currently using. This is either the static IP address of the interface
(if it is the master) or the management IP address (if it is a backup).
This field displays the interface's IP assignment. It will show DHCP or Static.
Use this field to get or to update the IP address for the interface.
Click Renew to send a new DHCP request to a DHCP server.
Click the Connect icon to have the ZyWALL/USG try to connect a PPPoE/PPTP
interface. If the interface cannot use one of these ways to get or to update its IP
address, this field displays n/a.
Click the Disconnect icon to stop a PPPoE/PPTP connection.
ZyWALL/USG Series User's Guide
95
Section 6.10 on page 115 for the