ZyXEL Communications USG40 User Manual page 647

Figure 451 Configuration > System > SNMP
The following table describes the labels in this screen.
Table 282 Configuration > System > SNMP
LABEL DESCRIPTION
Enable Select the check box to allow or disallow the computer with the IP address that matches
the IP address(es) in the Service Control table to access the ZyWALL/USG using this
service.
Server Port You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Get Community Enter the Get Community, which is the password for the incoming Get and GetNext
requests from the management station. The default is public and allows all requests.
Set Community Enter the Set community, which is the password for incoming Set requests from the
management station. The default is private and allows all requests.
Trap
Community Type the trap community, which is the password sent with each trap to the SNMP manager.
The default is public and allows all requests.
Destination Type the IP address of the station to send your SNMP traps to.
Service Control This specifies from which computers you can access which ZyWALL/USG zones.
Add Click this to create a new entry. Select an entry and click Add to create a new entry after
the selected entry. Refer to
Edit Double-click an entry or select it and click Edit to be able to modify the entry's settings.
Remove To remove an entry, select it and click Remove. The ZyWALL/USG confirms you want to
remove it before doing so. Note that subsequent entries move up by one when you take
this action.
Move To change an entry's position in the numbered list, select the method and click Move to
display a field to type a number for where you want to put it and press [ENTER] to move
the rule to the number that you typed.
Chapter 33 System
Table 276 on page 626
ZyWALL/USG Series User's Guide
647
for details on the screen that opens.