Wan Trunk; Figure 52 Status > Interface Status Summary, After Ethernet Interface Edits; Figure 53 Network > Interface > Trunk, Initial; Figure 54 Network > Interface > Trunk > Edit, Initial - ZyXEL Communications ZyWALL 1050 User Manual

Figure 52 Status > Interface Status Summary, After Ethernet Interface Edits

6.1.3 WAN Trunk

This example sets up trunk WAN_TRUNK with ge3 and ge4. This example uses the default
settings for the trunk and shows how to add the interfaces to it.

Table 32 Trunk Example

ETHERNET
INTERFACE
ge1
ge3
ge4
ge5
There are no existing trunks at the beginning of this example.
1 Click Network > Interface > Trunk. The following screen appears.
Figure 53 Network > Interface > Trunk, Initial
2 Click the Edit icon. The following screen appears.
Figure 54 Network > Interface > Trunk > Edit, Initial
3 Click the Member icon, as shown above. Select the ge2 and click the left arrow to
remove it from the member list. Do the same for aux. Select ge4 and click the right
arrow to add it to the member list. Then click OK.
ZyWALL 1050 User's Guide
TRUNK
---
WAN_TRUNK
WAN_TRUNK
---
Chapter 6 Tutorials
127