Host Name; Usb Storage - ZyXEL Communications USG40 User Manual

33.2 Host Name

A host name is the unique name by which a device is known on a network. Click Configuration >
System > Host Name to open the Host Name screen.
Figure 410 Configuration > System > Host Name
The following table describes the labels in this screen.
Table 264 Configuration > System > Host Name
LABEL
System Name
Domain Name
Apply
Reset

33.3 USB Storage

The ZyWALL/USG can use a connected USB device to store the system log and other diagnostic
information. Use this screen to turn on this feature and set a disk full warning limit.
Note: Only connect one USB device. It must allow writing (it cannot be read-only) and
use the FAT16, FAT32, EXT2, or EXT3 file system.
Click Configuration > System > USB Storage to open the screen as shown next.
Chapter 33 System
DESCRIPTION
Enter a descriptive name to identify your ZyWALL/USG device. This name can be up to 64
alphanumeric characters long. Spaces are not allowed, but dashes (-) underscores (_) and
periods (.) are accepted.
Enter the domain name (if you know it) here. This name is propagated to DHCP clients
connected to interfaces with the DHCP server enabled. This name can be up to 254
alphanumeric characters long. Spaces are not allowed, but dashes "-" are accepted.
Click Apply to save your changes back to the ZyWALL/USG.
Click Reset to return the screen to its last-saved settings.
ZyWALL/USG Series User's Guide
607