Address Group Summary Screen - ZyXEL Communications USG40 User Manual

Figure 368 IPv6 Address Configuration > Add/Edit
The following table describes the labels in this screen.
Table 231 IPv6 Address Configuration > Add/Edit
LABEL
Name
Object Type
IPv6 Address
IPv6 Starting
Address
IPv6 Ending
Address
IPv6 Address
Prefix
Interface
IPv6 Address
Type
OK
Cancel

32.5.2.3 Address Group Summary Screen

The Address Group screen provides a summary of all address groups. To access this screen, click
Configuration > Object > Address > Address Group. Click a column's heading cell to sort the
table entries by that column's criteria. Click the heading cell again to reverse the sort order.
Chapter 32 Object
DESCRIPTION
Type the name used to refer to the address. You may use 1-31 alphanumeric characters,
underscores( ), or dashes (-), but the first character cannot be a number. This value is
_
case-sensitive.
Select the type of address you want to create. Choices are: HOST, RANGE, SUBNET,
INTERFACE IP, INTERFACE SUBNET, and INTERFACE GATEWAY.
Note: The ZyWALL/USG automatically updates address objects that are based on an
interface's IP address, subnet, or gateway if the interface's IP address settings
change. For example, if you change 1's IP address, the ZyWALL/USG automatically
updates the corresponding interface-based, LAN subnet address object.
This field is only available if the Address Type is HOST. This field cannot be blank. Enter
the IP address that this address object represents.
This field is only available if the Address Type is RANGE. This field cannot be blank.
Enter the beginning of the range of IP addresses that this address object represents.
This field is only available if the Address Type is RANGE. This field cannot be blank.
Enter the end of the range of IP address that this address object represents.
This field is only available if the Address Type is SUBNET. This field cannot be blank.
Enter the IPv6 address prefix that the ZyWALL/USG uses for the LAN IPv6 address.
If you selected INTERFACE IP, INTERFACE SUBNET, or INTERFACE GATEWAY as the
Address Type, use this field to select the interface of the network that this address object
represents.
Select whether the IPv6 address is a link-local IP address (LINK LOCAL), static IP
address (STATIC), an IPv6 StateLess Address Auto Configuration IP address (SLAAC), or
is obtained from a DHCPv6 server (DHCPv6).
Click OK to save your changes back to the ZyWALL/USG.
Click Cancel to exit this screen without saving your changes.
ZyWALL/USG Series User's Guide
555