Language Screen; Ipv6 Screen - ZyXEL Communications USG40 User Manual

Table 282 Configuration > System > SNMP (continued)
LABEL
#
Zone
Address
Action
Apply
Reset

33.12 Language Screen

Click Configuration > System > Language to open the following screen. Use this screen to
select a display language for the ZyWALL/USG's Web Configurator screens.
Figure 452 Configuration > System > Language
The following table describes the labels in this screen.
Table 283 Configuration > System > Language
LABEL
Language Setting
Apply
Reset

33.13 IPv6 Screen

Click Configuration > System > IPv6 to open the following screen. Use this screen to enable
IPv6 support for the ZyWALL/USG's Web Configurator screens.
Chapter 33 System
DESCRIPTION
This the index number of the service control rule.
The entry with a hyphen (-) instead of a number is the ZyWALL/USG's (non-configurable)
default policy. The ZyWALL/USG applies this to traffic that does not match any other
configured rule. It is not an editable rule. To apply other behavior, configure a rule that
traffic will match so the ZyWALL/USG will not have to use the default policy.
This is the zone on the ZyWALL/USG the user is allowed or denied to access.
This is the object name of the IP address(es) with which the computer is allowed or denied
to access.
This displays whether the computer with the IP address specified above can access the
ZyWALL/USG zone(s) configured in the Zone field (Accept) or not (Deny).
Click Apply to save your changes back to the ZyWALL/USG.
Click Reset to return the screen to its last-saved settings.
DESCRIPTION
Select a display language for the ZyWALL/USG's Web Configurator screens. You also
need to open a new browser session to display the screens in the new language.
Click Apply to save your changes back to the ZyWALL/USG.
Click Reset to return the screen to its last-saved settings.
ZyWALL/USG Series User's Guide
648