Speaker System Measurement - Denon AVC-A1XVA Operating Instructions Manual

IV

. Speaker system measurement

• With these measurements, the "Speaker Configuration", "Delay Time", "Channel Level", "Crossover Frequency" and "Room EQ" are analyzed
automatically. The main listening position is measured first, so leave the microphone where it is.
1
(Main unit)
(Remote control unit)
NOTE:
• With these measurements, test tones are not output from channels to which speakers
have been judged not to be connected in the preliminary measurements. Do not change
the connection of speakers or the subwoofer's volume after performing the preparation
measurements and before performing these measurements.
q The screen shown at the right appears once the measurements for the main listening
2
position are completed.
Next the measurements for the second point will be taken. Place the microphone at the
second listening position. For instructions on the position in which the microphone should
be placed, see page 36. (When making the measurements, be sure to position the
microphone at the approximate ear height of the seated listener(s).)
(Main unit)
(Remote control unit)
3 Perform step 2 repeatedly.
The more measurement points, the better the resulting room correction effect. We recommend a minimum of 6 measurement points –
8 measurement points provides the best room correction effect.
Select the "OK Start" and press the cursor left
button.
Measurements for the first point start.
(Main unit)
(Remote control unit)
w Select the "OK Next" and press the cursor left
button.
Measurements for the second point start.
(Main unit)
(Remote control unit)
M a i n P o s i t i o n
O K S t a r t
2 n d P o s i t i o n
O K N e x t
39