Table of Contents
Advertisement
[2] Recording Dolby Digital and DTS multichannel sources
• With this set it is possible to record Dolby Digital and DTS multichannel signals converted into 2-channel analog signals.
• The recording signals are output to the TAPE and VCR output terminals.
• Down-mixed analog signals converted into digital signals are output from the OPTICAL 3, 4 and 5 digital output terminals at this time.
1
Press the ZONE3/4/REC SELECT button until "RECOUT
✽✽✽✽" (ZONE3 ✽✽✽✽) appears on the display. Then select
"RECOUT SOURCE".
(Main unit)
2
Set the input mode according to the source to be played.
(Main unit)
3
Set the surround mode by pressing the DIRECT/STEREO
button.
• The multichannel digital signals are down-mixed and output
to the TAPE and VCR output terminals.
(Main unit)
4
Set the recording mode.
This function does not work when "5.2 ch / 5.3 ch" is set for the
MAIN ZONE's channel setup.
[3] Dolby Headphone recording
• When RECOUT mode is set to "source", with the AVC-A1XVA it is possible to output signals encoded in the Dolby Headphone mode from
the recording output terminal and record them on a separate recorder.
1
The Dolby Headphone play mode is set when headphones are
connected to the PHONES jack during playback in the
DOLBY/DTS surround mode.
2
When this is done, signals encoded in the Dolby Headphone
mode are automatically output from the recording output
terminals (analog and digital) and can be recorded.
3
Select the parameters and set the desired mode, then record.
⁄0
(Refer to the
SURROUND "Dolby Headphone" pages 149,
150.)
136
(Main unit)
(Remote control unit)
(Remote control unit)
1
1
3
2
2
3
1
NOTE:
Do not disconnect the headphones during recording.
Hide quick links:
Advertisement
Table of Contents
