Measurement Flow - Denon AVC-A1XVA Operating Instructions Manual

2 Measurement flow

I. Connect the microphone to be used for the auto setup procedure.
Please place the measuring microphone at ear height at the main listening
position.
III.
Preliminary measurement items
q Measuring the background noise (noise in the room)
w Determining whether or not speakers are connected (speaker detection)
e Checking the polarities of the speakers
III.
Check the results of the speaker detection.
IV.
Speaker system measurement items
q Speaker Configuration : This sets the speaker bass reproduction ability.
w Delay Time
e Channel Level
 r Crossover Frequency : This set the frequency (Hz) below which the bass sound of the various speakers is to be output from


 t Room EQ
Continue measuring ?
Select "OK Next" and put the
microphone at next point.
V.
Check the results of the speaker system measurements.
V.
Store the measurement results in the memory.
Move the microphone to the 2nd
to 8th listening positions and
repeat the measurement.
34
By default, the speaker system
setting is set to 9.1 channels.
Please set under "Extra Setup",
only when you want to change
this arrangement.
II.
Extra Setup
q Channel Setup
w Power Amp Assign
(Main (1st) listening position)
: This sets the optimum delay time from each speaker corresponding to the listening position.
: This sets the volume that is output from each speaker.
the subwoofer.
: This sets the frequency response of each speaker.
Quit measuring ?
Select "Calculate".
NOTE:
• A moderately loud test tone is output during
the measurement. Please consider this should
you be planning night time measurements, and
consider not allowing small children into the
listening time.