3.9
Changing standard settings
The appliance has been set at the factory so that coffee can be
brewed without any additional programming.
The standard settings can be changed and adjusted. For this purpose
the "Standby", "Small cup", "Large cup", "Hot water" and "Steam"
buttons are assigned additional functions.
Button (a)
Standby
Button (e)
Small cup
Button (f)
Large cup
Button (g)
Hot water
Button (h)
Steam
The following settings can be changed:
►
Displayed language
►
Water hardness
►
Energy-saving mode
►
Cup heater
►
Rinsing
►
Reset
58300000116013_en_a – 21.08.06
Save settings
=
Selection button –
=
Selection button +
=
Selection button
=
Access programming mode
=
3.9.1
Programming
Before the programming can be changed, the appliance must be in
brewing mode.
Ready
is displayed.
Press and hold down steam button (h) for at least three seconds. –
Programming mode is activated.
►
Press the selection button (g) to select the required setting,
Hardness
Setting 3
e.g.
//
►
To change the setting, press button (e) or (f), e.g.
Setting 2
//
►
Press Standby button (a) once. The changed setting is saved.
Ready
is displayed again.
Hardness
Seite 14 von 61