7.5
Outgoing goods inspection
The outgoing inspection ensures that the appliance satisfies the
requirements after the service
►
The outgoing inspection must be conducted in full!
►
Eliminate faults and deviations and then conduct the outgoing
inspection again in full!
1. Fully open and close the sliding door by hand
►
The sliding door must move easily into the respective
mechanical end stops of the appliance.
►
CLOSED pos.: Sliding door projects over the aluminium profile
equally on both sides.
►
OPEN pos.: Right edge of door must be flush with the right
edge of the aluminium profile or retracted slightly.
2. Insert mains plug, switch on mains switch on the appliance
►
Sliding door closes automatically. Sliding door must move into
the mechanical end stop of the appliance and must not slightly
jump open again.
3. Press Standby button
►
Sliding door opens. Sliding door must move into the
mechanical end stop of the appliance and must not slightly
jump shut again.
58300000116013_en_a – 21.08.06
4. Wait for automatic rinsing process
►
Only possible when the temperature of the heater has
dropped below 40 °C.
Service
►
Is
and then
►
How long does the machine require to heat up?
(Standard time approx. 50 sec.)
►
Is a rinsing process taking place?
►
Is standby indicated on the display by
5. Check Standby button light function
►
It must come on as soon as the main switch was switched on.
6. Press Standby button and measure the time required for
closing the sliding door
►
Target 1.0 – 1.5 seconds
7. Press Standby button and measure the time required for
opening the sliding door
►
Target 1.0 – 1.5 seconds
►
After the appliance is ready to use again, close the sliding
door by hand.
8. Move hand towards the disc on the sliding door
►
Sliding door opens.
Rinse
displayed?
Ready
?
Seite 57 von 61