Table of Contents
Advertisement
6.5.2
Step 2: Inserting the mains switch holder
1.
Screw on the inner support with screw (5), Torx T10 3.0 x 12.
2.
Insert support with mains switch into guide and screw into
place with screw (4), Torx T10 3.0 x 12.
Observe tightening torque of the screws!
0.5 Nm – 0.9 Nm.
58300000116013_en_a – 21.08.06
6.5.3
Step 3: Inserting the water tank holder
During assembly install hoses correctly!
1.
Put water tank holder over the heater and guide the silicone
hose between the water pipe and heater coil.
2.
Push on silicone hose (2) all the way at the bottom of the
flowmeter.
3.
On the other side connect wires to the mains switch: brown
wire from power cable at top, violet cable at bottom.
4.
Position water tank holder ready on the support, screw to the
base with 4 screws Torx T10, 3.0x12, as well as with one
screw Torx T10, 3.0x12 black. Ensure that the silicone hose (2)
is positioned over the screw boss (1) and not next to it.
Seite 42 von 61
Hide quick links:
Advertisement
Table of Contents
