Assembly - WAGNER GM 4700AC Operating Manual

VERSION 06/2014
OPERATING MANUAL
10.8.4

ASSEMBLY

1. Apply the Loctite 638 to the thread and between the hollow screw and fi lter
connection.
2. Put the fi lter connection into the gun connection, align and tighten the hollow
screw with a tightening torque of 15 Nm; 11 lbft.
Exceeding the allowable torque will damage the fi lter connection.
3. Harden the adhesion point in the housing in a oven at 40 °C; 104 °F for at least 30
minutes.
Defective parts!
Leakage caused by defective parts
The resulting spray jet can inject product into your body (skin, eyes
etc.)
4. After cooling off , completely assemble the spray gun. In doing so, note the assembly
information in the spare part drawing in Chapter 14.2 of the operating manual.
5. Use a suitable medium to check the spray gun for leaks at 25 MPa; 250 bar; 3626 psi
or 16 MPa; 160 bar; 2320 psi.
ORDER NUMBER DOC2311730
WARNING
Always replace defective parts, o-rings and seal sets.
Ensure that adhesion points are clean and grease-free.
Do not exceed the specifi ed torque of 15 Nm; 11 lbft!
GM 4700AC
58