Typical Fi Elds Of Application - Nilfisk-Advance C 125.4 Instructions For Use Manual

Hide thumbs Also See for C 125.4:
Table of Contents

Advertisement

5.2 Typical fi elds of application
EN
Below you will fi nd a description of a lot of cleaning tasks which can be solved by a pressure washer from
Nilfi sk in association with accessories and detergents.
DA
Task
NO
Car
SV
FI
DE
FR
NL
IT
Rims, alumi-
nium
ES
PT
Flagstones,
concrete
fl oors and
EL
other hard
surfaces
TR
Garden furni-
ture, wood
CS
HU
Brickwork,
PL
Wood work
HR
Gutter
SL
Cleaning of
drain pipes,
SK
outlets, down
pipes etc.
LV
Rust, paint
LT
Greenhouse
ET
Garden tools,
lawn mover
RU
ZH
14
Accessories 'Click
Cleaning method
& Clean'
Car nozzle,
1. Apply Car Combi Cleaner with the foam sprayer. Always
auto brush,
underchassis
nozzle,
2. Wash the car with the car nozzle, which has been optimized for
Foam sprayer,
Car Combi Cleaner
3. Use the brush for removal of traffi c fi lm which is not removed by the
4. Attach the undercarriage nozzle and clean undercarriage and
5. Remove water from the surface of the car with the scraper
Multi Brush with
Apply Car Combi Cleaner with the foam sprayer or the Multibrush
Rim brush head,
with detergent tank. Let it act for approx. 5 min.. Wash with rim
auto nozzle,
brush head.
foam sprayer,
Be careful! The high pressure jet may damage the tyres.
Car Combi Cleaner
®
Powerspeed
Wash towards outlets or the like. On surfaces with foulings you
nozzle,
may start by applying Stone & Wood Cleaner with
Stone & Wood
the foam sprayer. Wash before the soap dries. Another
Cleaner,
more effective and quicker method is to use the Patio
Patio Cleaner
Cleaner. Thus you will also avoid splashes.
Multi Brush with
Apply Stone & Wood Cleaner with foam sprayer or Multi Brush
Garden brush head
with Garden brush head and wash before the soap dries.
(with or without
NOTE: Use the Multi Brush with Garden brush head to clean off
detergent tank)
the dirt.
Stone & Wood
Cleaner
Foam sprayer
Powerspeed
®
Same method as for fl agstones, but be careful - bad joints and
nozzle,
wood may be damaged by high pressure. You may choose only
Stone & Wood
to use the Tornado
Cleaner,
the quality of the joints and the wood. Patio Cleaner can also be
Patio Cleaner
used on vertical surfaces.
Underchassis spray
Wash the gutter with the nozzle. Always wash towards
lance
downpipes. Beware not to spray under the roofi ng.
Tube cleaner
Push the tube cleaner approx. ½ m (to mark) into a tube or drain
and activate the trigger of the spray handle. The nozzle opening
turning backwards will pull the cleaner through the tube. The
nozzle will break down the „plug" and fl ush the dirt backwards.
Water/sandblasting
Mount the water/sand blasting equipment and rust and paint
equipment
is effi ciently and quickly removed. Beware not to damage the
surface to be sandblasted.
®
Tornado
PR nozzle
Wash with high pressure and maybe a brush. You may use Stone
brush, Stone &
& Wood Cleaner to remove moss and algae.
Wood Cleaner
®
Tornado
PR
Rinse the worst dirt off with the nozzle. Apply Metal Cleaner with
nozzle, Power-
the foam sprayer and let it act for approx. 5 min. Wash with the
®
speed
nozzle,
nozzle. You may use the multiangle adaptor for hard to get at
multiangle adaptor,
areas to avoid splashing.
Metal Cleaner
start from the bottom and work upwards. Let Car Combi
Cleaner act for at least 5 min.
quick and gentle cleaning of enamelled surfaces (the jet is wider
and not so sharp). Start at the front of the car and work back-
wards to avoid water from penetrating by the door mouldings.
nozzle. If the car is very dirty, apply Car Combi Clean er again.
wheel arches.
on the car brush. Make sure that all grains of sand etc. have
been removed before using the scraper. Wipe with a wash lea-
ther where the scraper cannot reach.
®
nozzle. Adjust the distance (pressure) to
Original Instructions

Advertisement

Table of Contents
loading

This manual is also suitable for:

C-pg 130.2 x-traC 130.2E 130.2

Table of Contents