Integra DTR-4.9 Service Manual page 85

QQ
3 7 63 1515 0
DEBUG MODE-5
HDMI DEBUG MODE-1/2
HDMI-related operations can be checked to some extent by displaying HDMI debug mode.
To enter this mode
Hold down Display Display button for 3 seconds. Information display will last for about 8 seconds.
Content of Display
Segment No. --->
0
Video Input Format
Normal Source
Video Formats
TE
L 13942296513
www
.
http://www.xiaoyu163.com
1 2 3 4
FL segment No. --->
Status Description
Description --->
Source Device Video Format : OK, Display --->
Sink Device EDID : OK
(Example)
Normal State
Source Device Video Format : OK
Sink Device Hot plug : Low
Error State ---> Remedy 1
Source Device Video Format : OK
Sink Device HDCP Authentication : Fail
Error State ---> Remedy
2
Source Device Video Format : OK
Sink Device Resolution : Error
Error State ---> Remedy
3
Source Device Video Format : OK
Sink Device EDID Reading : Error
Error State ---> Remedy
4
Source Device Video Format : OK
Sink Device :
Busy(Cannot accept HDMI signal)
Error State ---> Remedy 5
Description --->
Progressive/ Interlace
i : HDMI, Interlace
p : HDMI, Progressive
I : DVI, Interlace
P : DVI, Progressive
Frame Rate
/6 : 60 frame/sec
/5 : 50 frame/sec
Video signal input
: HDMI input
x ao
y
i
http://www.xiaoyu163.com
8
FL Display
5 7 6 8 9
0 1 2 3 4
Input Resolution i/p/I/P
Q Q
3 6 7 1 3
Input Resolution i/p/I/P
i/p/I/P
u163
.
2 9 9 4 2 8
10 11 12 13 14
5 6 7 8 9 10
Frame Rate Output Resolution
1 5 0 5 8 2 9 9 4
Blinks
Frame Rate Output Resolution
m
co
DTR-4.9
9 9
11 12 13 14
i/p/I/P
2 8 9 9
Error mark
Error mark
Error mark
i/p/I/P