Guidelines For Safe R/C Helicopter Flight; Necessary Items - Compass 3D Plus Nitro Powered Helicopter Assembly Manual

Guidelines for Safe R/C Helicopter Flight

• Fly only at approved flying fields and obey field regulations.
• Follow frequency control procedures. Interference can be dangerous to all.
• Obtain guidance from experienced pilots.
• The guidance provided by experienced pilots is often valuable and sometimes necessary.
• Know your radio. Check all transmitter functions before each flight.
• Be aware that rotating blades are very dangerous and can cause serious injury.
• Never fly near or above spectators or other modelers.
• Do not fly r/c helicopter models near buildings, high voltage cables, trees or other obstacles.
• If a beginner, get help trimming the model first and flight training later.
• Don't "track" the main blades by holding the tail boom. This is a temptation to builders who cannot hover yet and is very dangerous.
• Follow all recommended maintenance procedures for model, radio and motor.
• Only turn off the radio after the engine is shut down.
In order to operate this model, you need to purchase the following items not kit-included.
At least a 6 channel radio and receiver
4 standard servos.
1 gyro with rudder servo.
5V receiver battery
or 2 cell li-po battery with a regulator.
Main Rotor Blades
Length: 600~ 620mm
Hex Wrench
(1.5mm,2mm,2.5mm,3mm)
Pitch Gauge
Engine Starter
Class 50 Engine

Necessary Items

Thread Lock
Cutter Knife
Ball Link Sizing Tool
Glow Igniter
Muffler for 50 Class
Battery
Grease
Needle Nose Pliers
Swashplate tool
Starter Shaft
Glow Fuel for
Model Engines
Gyro
Bearing Retainer
Screw Driver
Ball Link Plier
Fuel Filter
Fuel Pump