Markings; Attaching Body - Tamiya HOTSHOT User Manual

1/10 scale r/c high performance off road racer
Table of Contents

Advertisement

*Make hole. (7mm)
*Loch bohren. (7mm)
*Percer un trou. (7mm)
*Use extra stickers as you wish.
*Zusätzliche Aufkleber nach Belieben anbringen.
*Apposer les autocollants additionnels à vorte gré.
Markings
Verzierung
Décoration
*Apply stickers in numbered order.
*Aufkleber der Reihenfolge nach anbringen.
*Appliquer les autocollants dans l'ordre numérique.
Attaching body
Aufsetzen der Karosserie
Fixation de la carrosserie
Wing
Spoilers
Aileron
Snap pin (small)
Federstift (klein)
Epingle métallique (petite)
Body
Karosserie
Carrosserie
ITEM 74005
ANGLED TWEEZERS
ITEM 74003
•1A1V1.I YA
46
STICKERS
Cut stickers along colored edge
so that transparent film is removed.
Peel off the end of lining a little
and put the sticker in position on the
body.
Then, remove the lining slowly. In
doing so, be careful that the sticker
does not move out of position on the
body.
If the lining is completely removed in
advance, the sticker may become
wrinkled or contain unwanted air
bubbles.
AUFKLEBER
Die Aufkleber an den bunten
Kanten so ausschneiden, daß der
transparente Film weg ist.
©An einer Kante die Unterlage
etwas abziehen und die Aufkleber
richtig auf die Karosserie legen.
Dann die Unterlage langsam ganz
abziehen, darauf achten, daß sich
die Aufkleber nicht verschiebt und
daß keine Luft unter den Aufkleber
kommtsonst gibt es Luftblasen.
Wenn die Unterlage vorher komplett
entfernt wird, kann der Aufkleber
zusammenkleben.
MOTIFS ADRESIFS
Découper chaque motif au plus
près de ses contours pour éliminer
le film transparent.
©Soulever le papier de protection à
l'une des extrémités et positionner
le motif sur la carrosserie.
®Retirer lentement le papier de
protection en veillant à ce que le
motif ne se déplace pas sur la
carrosserie.
En retirant entièrement à l'avance le
papier de protection, le film risque
de former des plis ou de retenir des
bulles d'air indésirables.
Snap pin (large)
Federstift (groß)
Epingle métallique (grande)
CURVED SCISSORS
*Avoid continuous running. Allow the motor to cool after each
battery run.
*Permanenten Motoreinsatz vermeiden. Den Motor möglichst nach
jedem Fahrbetrieb abkühlen lassen.
*Eviter de rouler continuellement. Laisser le moteur refroidir après
chaque accu.
21
58391 Hotshot (2007) (11050646)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents